Hair clip from foamiran "Jasmine"

This hair clip will be a great decoration for hair in the summer.

For the manufacture we need the following materials:

- green corrugated paper.

- plastic suede in white and green.

- lighter.

- scissors.

- stamens for flowers.

- a few beads.

- glue gun.

- hair clip-hair clip.

- floristic wire.

We will prepare a petal template - this will be a blank of four petals in a diameter of 5 cm.

We need to make 8 such blanks.

Now you need to cut all the petals of cloves, in each workpiece along the upper edge.

For further work, you need to process the petals for the flower, knead with your fingers. Take alternately the petals. And we put its 4 parts on top of each other.

And twist them together, turning the fingers.

Then slightly unwind back and with your fingers we stretch each part of the petal, in the middle.

And then we warm the middle of the petal with a lighter, and use some stick with a rounded edge to create a recess in the workpiece. The deepening will be from the inside.

The basics for the flowers are ready. Take the stamens. You can use ready-made, purchased, or you can make from beads yourself.

In the finished flowers with a glue gun, glue the stamens.

There were sepals for the flowers. Cut them out of 2x2 cm squares. From them, cut the blanks in the form of a petal with 4 leaves. They need 8 pieces.

When cut out, also scroll the edges with your fingers.

And glue them to the flowers.

To get a twig, cut the wire 0.8 mm. For the branch itself, 1 piece is 8 cm. For leaves and buds, 10 pieces are 5 cm long. And cut thin strips of corrugated paper to paste over this wire.

Now we take the blanks of the leaves and cut the sepals for the buds from the squares of 0.8x0.8 cm. In the same way as for the flowers. And the leaves will be 4x3 cm in size. Cut them 5 pieces. Make sharp notches around the edges.

Also scroll them with your fingers and straighten in the middle.

We take a plastic sheet, you can use a bay leaf, and with it we will make veins of leaves. You can warm the sheet with a lighter and immediately attach it to the plastic base, pressing it well against each other. Beautiful prints are obtained. Now from the wrong side we glue a glued wire 5 cm long to each sheet. There will be 5 leaves with wires.

Now proceed to the buds. The sepals are ready, cut out white petals from plastic suede. For them we use trimmings after cut flowers. And we cut them in the form of droplets of small size, 5 pieces per 1 bud.

We take the glued wire and on its edge we attach the white petals with a glue gun.

And then we fix the sepals.

It is time to build a twig. We take the main wire 8 cm long, on the upper edge we attach a bundle of 3 buds and 1 sheet. We close the joints with corrugated paper. Going down 2 cm, we fix another 2 sheets, and after 3 cm we again attach a bunch of two buds and 2 leaves, and wrap the paper to the edge of the entire main wire.

Now we take ready-made flowers and fix them on a twig, spreading along the entire length.

From the wrong side with a glue gun we fix a large hairpin-clip. The decoration is ready. It remains to decorate with beads. This can be done as desired.

Well, that's all the branch is decorated, the hairpin is ready.

Good luck to all.